You have no items in your shopping cart. Add items to checkout.
You're currently on:
EMX IRB-4X Infrared Photoeye
FEATURES:
• Built in noise filter
• Power indicator LEDs
• Potentiometer range adjustment allows more precise tuning to site
• Wide 24° transmission angle allows easier alignment and increases reliability
• Through beam design is not affected by shiny surfaces
• Modulated infrared to reduce the effect of sunlight, fog, rain, dust and dirt
BENEFITS:
• Reliability
• Longer Range
• Improved interference rejection
• Precise tuning
• No focusing lens
| Range | 25-115 Ft. |
| Power | 12-24V AC/DC TX=37mA, RX=23mA Standby / 17mA Detect |
| Relay Contacts | 5A @ 30VDC/250VAC |
| Housing | NEMA 4X Plystyrene |
| Transmitter | Infrared Modulated Photocell |
| Receiver | Infrared Modulated Photocell |
| Dimensions | 3.7" x 2.56" x 2.24" |
| Brochures | prod_brochures/emx/irb-4x.pdf |
Photo Eyes
Photo eyes are commonly used on slide gates in place of safety loops. Instead of installing a loop buried in the ground on each side of the gate, one photo eye is used, saving time and money. A vehicle detector is still used for exiting.
Photo eyes are used as safety device for entrapment zones on swing and sliding gates. An entrapment zone is an area where a person may be trapped by a moving gate and an obstacle such as a fence. If the photo eye is interrupted the gate will reverse.
There are two types of photo eyes. Reflective photo eyes have both the transmitter and receiver built in, and use a reflector to bounce the beam back. Receiver/transmitter types use two separate units, one transmits a beam and the other receives it. Be sure to purchase a photo eye with at least a third more range than you need to be on the safe side. Beam distance degrades after the optics or reflector get dirty, and during the rain.



























